> For the complete documentation index, see [llms.txt](https://begonova.gitbook.io/rose-go/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://begonova.gitbook.io/rose-go/print-preparation.md).

# Print Preparation

## **Step 1**

Place the print surface on the platform, paying attention to aligning the corners.

![](/files/-MBV4CKSgX4-02-BE4eO)

## **Step 2**

Click home to reset the printer.

![](/files/-MBV47ga4Hb9Lwbti0nW)

## **Step 3**

Click the leveling button to automatically level the print surface.

![](/files/-MBV4IlFw_pGC3JbfAvH)

## **Step 4**

Click on auto leveling and wait for a few minutes for auto leveling.

![](/files/-MBV4NLQpUMJIu7gU1cO)

## **Step 5**

After leveling, click the middle point among the 5 points on the left to move the print head to the center point of the platform.

![](/files/-MBV4S2e31iHBH2njK23)

## **Step 6**

Fold A4 paper in half and push it under the nozzle.

![](/files/-MBV4WbO2PBWaPwmY_JK)

## **Step 7**

Push A4 paper back and forth, feel if there is resistance, fine-tune at the screen.

![](/files/-MBV4a4-2lPgXnj_JmI1)

## **Step 8**

Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.

![](/files/-MBV4fDla9AQl8RMvXJX)

## **Step 9**

Adjust up and down until there is a little resistance to the paper pulling, just push the paper to bend (note that it cannot be too tight so that the paper cannot be pulled at all).

![](/files/-MBV4klmG7hFNab2Xu2Q)

## **Step 10**

Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.

![](/files/-MBV4psVMp52W_ASysn8)

## **Step 11**

Put in the filament spool, pay attention to the direction of the filament spool.

![](/files/-MBV4uxgvOk1UIvAbrRM)

## **Step 12**

The filament have a certain bending angle at the beginning, which is not easy to push into the extruder.Bend the filament by hand to make them straight at least 10cm long.

![](/files/-MBV4zhF9Zs579YN1OcA)

## **Step 13**

Cut a sharp angle at the front end of filament with diagonal pliers.

![](/files/-MBV524LIEvWGk865GYy)