Print Preparation
Last updated
Last updated
Place the print surface on the platform, paying attention to aligning the corners.
Click home to reset the printer.
Click the leveling button to automatically level the print surface.
Click on auto leveling and wait for a few minutes for auto leveling.
After leveling, click the middle point among the 5 points on the left to move the print head to the center point of the platform.
Fold A4 paper in half and push it under the nozzle.
Push A4 paper back and forth, feel if there is resistance, fine-tune at the screen.
Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.
Adjust up and down until there is a little resistance to the paper pulling, just push the paper to bend (note that it cannot be too tight so that the paper cannot be pulled at all).
Click two adjustment buttons to adjust the nozzle position up and down to make first layer stick to print surface.
Put in the filament spool, pay attention to the direction of the filament spool.
The filament have a certain bending angle at the beginning, which is not easy to push into the extruder.Bend the filament by hand to make them straight at least 10cm long.
Cut a sharp angle at the front end of filament with diagonal pliers.
